TRENDnet TEW-630APB Router Manual (Setup & Configuration)

There is no better technical help than having the manual of any given product. Fortunately, we are presenting router guide for TRENDnet TEW-630APB router. If you need help on topics like web panel access for management, router hard reset, parental control settings, band width allocation, changing your router IP or password from default, port forwarding, then reading this guide is a must.

Page 1 / 11
TEW-630APB
Quick Installation Guide
Page 2 / 11
English
......................................................................................................
Troubleshooting
........................................................................................
1
1
2
3
6
1. Before You Start
2. Install Hardware
.................................................................................
3. Configure the Access Point
................................................................
.................................................................................
Table of Contents
Version 04.13.2007
Page 3 / 11
Installation Requirements
Application
Package Contents
1. Before You Start
English
1
HD
DATA
300Mbps, share multimedia throughout the house
300Mbps Wireless N
Access Point
(TEW-630APB)
?
?
A computer with a network adapter properly installed
?
A network Switch or Hub with an available network LAN port
A RJ-45 network cable
A web browser such as Internet Explorer (5.5 or higher)
?
?
?
Quick Installation Guide
User's Guide CD-ROM
TEW-630APB
?
?
AC Power Adapter (12V DC, 1A)
?
1 x RJ-45 Ethernet
Page 4 / 11
2. Install Hardware
English
2
2.
Connect the AC Power Adapter to
the Access Point and then to a
power outlet.
Note: Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network. Please connect
the computer configuring the TEW-630APB to the same switch/hub.
1.
Connect a RJ-45 cable from the
Switch/Hub to the
LAN
port of the
Access Point.
3.
Verify that the following front panel
lights are on:
Power, LAN
and
WLAN
.
Page 5 / 11
English
3
3. Configure the Access Point
Note: It is recommended that you configure the Access Point from a wired
computer.
Before the Access Point can be configured, a Static IP address
must be assigned to your computer's network adapter in the subnet of
192.168.1.x.
Since the Access Point's default IP address is 192.168.1.100,
make sure no other network devices are assigned an IP address of
192.168.1.1.
(Refer to the Troubleshooting section on how to configure TCP/IP
settings on your PC)
2.
Enter User name and Password,
and then click
Log in
.
User name:
admin
By default, there is no password.
1.
Open your web browser, type
in the
Address bar, and press
Enter
.
3.
Click
Launch Wireless Setup
Wizard.
4.
Click
Next
.