TRENDnet TEG-448WS Router Manual (Setup & Configuration)

There is no better technical help than having the manual of any given product. Fortunately, we are presenting router guide for TRENDnet TEG-448WS router. If you need help on topics like web panel access for management, router hard reset, parental control settings, band width allocation, changing your router IP or password from default, port forwarding, then reading this guide is a must.

Page 1 / 10
TEG-448WS
H/W: B2
Quick Installation Guide
Page 2 / 10
English
......................................................................................................
1
1
3
2
1. Before You Start
2. Hardware Installation
........................................................................
3. Web Management Utility
....................................................................
................................................................................
Table of Contents
Version 03.31.2008
Troubleshooting
........................................................................................
6
Page 3 / 10
System Requirements
Application
TEG-448WS
Quick Installation Guide
Utility and User Guide CD-ROM
2 mounting brackets with screws
Rubber Cushions
AC Power Cord
Web Browser: Internet Explorer (5.0 or above)
Computer with Network adapter installed
(Optional) 4 Mini-GBIC Modules (e.g. TEG-MGBSX, TEG-MGBS10,
TEG-MGBS40, TEG-MGBS80, TEG-MGBS10D3_5, TEG-MGBS40D3_5)
Package Contents
1. Before You Start
English
1
Gigabit
48-Port Gigabit Web Smart Switch
(TEG-448WS)
Multi-Mode Mini
GBIC Module
(TEG-MGBSX)
Multi-Mode Mini
GBIC Module
(TEG-MGBSX)
Workstation with
10/100Mbps PCI Adapter
(TE100-PCIWN)
Servers with
Gigabit PCI Adapters
(TEG-PCITXR)
26-Port Gigabit Web Smart Switch
(TEG-224WSplus)
Cable/DSL
Modem
LC Type Cable
4-Port Gigabit Firewa l Router
(TWG-BRF114)
Internet
10/100Mbps
Workstation with
10/100Mbps PCI Adapter
(TE100-PCIWN)
Page 4 / 10
2. Hardware Installation
English
2
2.
Connect a CAT-5e/6 RJ-45
network cable from the computer to
an available Ethernet port of the
TEG-448WS.
1.
Connect the
Power Cord
to the
rear of the TEG-448WS
and
then to a power outlet.
Note
:
1. After hardware installation is complete, use the Web-based Smart Utility to
configure the TEG-448WS. To access the Web-based Smart Utility, open
your web browser, and enter the default IP Address http://192.168.0.1 and
default password "admin". Make sure your computer and the TEG-448WS
are configured to the same network segment.
2. The Mini-GBIC slots are shared with Gigabit Ethernet ports 45, 46, 47 and
48. When the Mini-GBIC slots are in use, Gigabit Ethernet ports 45, 46, 47
and 48 are disabled.
Page 5 / 10
English
3
3. Web Management Utility
For Windows User
1
. Insert the
Utility CD-ROM
into
your computer's CD-ROM Drive
and then click
Install Utility
.
2.
Follow the
Installation Wizard
instructions. Click
OK
.
Note:
If you would like to easily discover all the Web Management Switches on
the network, assign IP Address, change the password, and upgrade to new
firmware, then install the Web Management Utility. Follow the steps below.
3.
Click
Start
>
Programs
>
TRENDnet
>
Web Smart Switch
Management Utility
, and
then click
Web Smart Switch
Management Utility.