TRENDnet TEG-240WSv3 Router Manual (Setup & Configuration)

There is no better technical help than having the manual of any given product. Fortunately, we are presenting router guide for TRENDnet TEG-240WSv3 router. If you need help on topics like web panel access for management, router hard reset, parental control settings, band width allocation, changing your router IP or password from default, port forwarding, then reading this guide is a must.

Page 1 / 9
TEG-160WS
TEG-240WS
Quick Installation Guide
Downloaded from
www.Manualslib.com
manuals search engine
Page 2 / 9
Table of Contents
English
......................................................................................................
Troubleshooting
........................................................................................
1
1
3
2
6
1. Before You Start
2. Hardware Installation
........................................................................
3. Web Management Utility
....................................................................
................................................................................
Table of Contents
Version 04.28.2006
Downloaded from
www.Manualslib.com
manuals search engine
Page 3 / 9
System Requirements
Application
TEG-160WS/TEG-240WS
Quick Installation Guide
Utility
& User Guide CD-ROM
2 Mounting Brackets with Screws
Power Cord
Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above)
Computer with Network adapter installed
Package Content
1. Before You Start
English
1
Workstations with
10/100Mbps Ethernet Card
(TE100-PCIWN)
Servers with 10/100/1000Mbps
Copper Gigabit PCI Adapter
(TEG-PCITXR)
Workstations with 10/100/1000Mbps
Copper Gigabit PCI Adapter
(TEG-PCITXR)
gigabit
16-Port 10/100/1000Mbps Gigabit
Web Smart Switch
(TEG-160WS)
24-Port 10/100/1000Mbps Gigabit
Web Smart Switch
(TEG-240WS)
Or
Downloaded from
www.Manualslib.com
manuals search engine
Page 4 / 9
2. Hardware Installation
English
2
2.
Connect a CAT-5 RJ-45 network
cable from the computer to an
available Ethernet port of the
TEG-160WS/TEG-240WS.
1.
Connect the
Power Cord
to the
rear of the TEG-160WS/
TEG-240WS
and then to a power
outlet.
Note: After hardware installation is complete, use the Web-based Smart Utility
to configure the TEG-160WS/TEG-240WS. To access the Web-based Smart
Utility, open your web browser, and enter the default IP Address
and default password "admin". Make sure your computer
and the TEG-160WS/TEG-240WS are configured to the same network
segment.
Downloaded from
www.Manualslib.com
manuals search engine
Page 5 / 9
English
3
ote: If you would like to easily discover all the Web Management Switches on
the network, assign IP Address, change the password, and upgrade to new
firmware, then install the Web Management Utility. Follow the steps below.
3.
Click
Start
>
Programs
>
web_management_utility
, and
then click
web_management_utility
.
3. Web Management Utility
For Windows User
1
. Insert the
Utility & User’s Guide
CD-ROM
into your computer's
CD-ROM Drive and then click
Install Utility
.
2.
Follow the
Installation Wizard
instructions. Click
OK
.
Downloaded from
www.Manualslib.com
manuals search engine