CTC-Union ATU-R130 Router Manual (Setup & Configuration)

There is no better technical help than having the manual of any given product. Fortunately, we are presenting router guide for CTC-Union ATU-R130 router. If you need help on topics like web panel access for management, router hard reset, parental control settings, band width allocation, changing your router IP or password from default, port forwarding, then reading this guide is a must.

Page 1 / 74
ADSL Ethernet Bridge/Router
Page 2 / 74
Page 3 / 74
ATU-R130 User’s Guide
This manual may not be copied, photocopied, transmitted, or translated into language or computer
language, in any form, or by any means, in whole or in part, without the prior written consent by the
© Copyright 2003 All rights reserved.
The manufacturer makes no representations or warranties, expressed, statutory or implied, regarding
the fitness or merchantability of this product for any particular purpose. Further, the manufacturer is
no liable for any damages, including but not limited to, lost profits, lost saving, or other incidental or
consequential damages arising out of the use of this product. The manufacturer also reserves the right
to make any improvements or modifications to the product described in this manual at any time,
without notice of these changes.
Page 4 / 74
ATU-R130 ADSL Ethernet Router User’s Guide
Federal Communications Commission (FCC) NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient of relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
Consult the dealer or an experienced radio / TV technician for help.
This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to insure compliance. This statement can be deleted if unit was not tested with
shielded cables.
The manufacture is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
This device may not cause harmful interference.
This device must accept any interference that may cause undesired operation
Always disconnect all telephone lines from the wall outlet before servicing or disassembling this
Page 5 / 74
ATU-R130 User’s Guide
When using your telephone equipment, basic safety precautions should always be followed to reduce
the risk of fire, electric shock and injury to persons, including the following;
Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink or
laundry tub, in a wet basement or near a swimming pool.
Avoid using a telephone (other then a cordless type) during an electrical storm.
There may be a
remote risk of electric shock from lighting.
Do not use the telephone to report a gas leak in the vicinity of the Leak.
Use only the power cord and batteries indicated in this manual.
Do not dispose of batteries in a
They may explode.
Check with local codes for possible special disposal Instructions.