BaudTec T263R1U Router Manual (Setup & Configuration)

There is no better technical help than having the manual of any given product. Fortunately, we are presenting router guide for BaudTec T263R1U router. If you need help on topics like web panel access for management, router hard reset, parental control settings, band width allocation, changing your router IP or password from default, port forwarding, then reading this guide is a must.

Page 1 / 16
Page 2 / 16
ADSL2+ Router
Page 3 / 16
ComTW263R4
2
ADSL2+ Router
ADSL2+ Router
System Requirement
1.
Pentium 200 MHz processor or above
2.
Windows 98SE, Windows Me, Windows 2000, Windows XP and
Windows Vista.
3.
64 MB of RAM or above
4.
25 MB free disk space
Package Contents
For Annex-A ADSL2+ Router
1.
ADSL2+ Router
2.
CD-ROM (Software & Manual)
3.
Quick Installation Guide
4.
1 x Telephone Cable (RJ-11)
5.
Ethernet Cable (RJ-45)
6.
AC Adaptor
7.
Annex A ATF085A1R Splitter (Optional, with an extra RJ-11
Telephone cable)
For Annex-B ADSL2+ Router
1.
ADSL2+ Router
2.
CD-ROM (Software & Manual)
3.
Quick Installation Guide
4.
1 x Telephone Cable (RJ-11)
5.
Ethernet Cable (RJ-45)
6.
AC Adaptor
7.
Annex B ATF057R Splitter (Optional, with an extra RJ-11 Telephone
cable)
Page 4 / 16
3
ADSL2+ Router
Installation & Setup
LAN Connection:
Connect an Ethernet cable from your PC's Ethernet port to ADSL2+ Router's
LAN Port.
WAN Connection:
Connect the telephone cable from your home's telephone jack to the
telephone port (LINE) of the ADSL2+ Router, if there is no Splitter applied.
Power Adapter Connection:
Connect the power adapter to the power inlet (PWR) of the ADSL2+ Router
and turn the power switch (SW) on.
Figure 1: Rear View of the ADSL2+ Router
Page 5 / 16
ComTW263R4
4
ADSL2+ Router
Connection of ADSL2+ Router
If you have an ISDN telephone line
connected the router as shown below:
(Annex-B ADSL2+ Router)
**Use the “ATF057” Annex-B Splitter (Optional)
1.
Connect the supplied RJ45 Ethernet cable from your PC's Ethernet
port to the ADSL2+ Router's “LAN” Port.
2.
Connect the supplied RJ11 telephone cable from your home's
telephone jack to the “LINE” port of the supplied ATF057 splitter.
Connect the other supplied RJ11 telephone cable to the “MODEM”
port of the splitter and connect the other end of this cable to the “LINE”
port of your ADSL2+ Router.
3.
Connect a RJ11 telephone cable to the “PHONE” port of the splitter
and connect the other end to the telephone input.
4.
Connect the power adapter to the power inlet (PWR) of the ADSL2+
Router and turn the “SW” switch of your ADSL2+ Router on.